03 · Concrete Equipment

Bull Float

Also called Magnesium float · Concrete float

A wide float on a long handle that levels fresh slabs and removes ripples right after screeding.

Manual / non-powered

Selected model

Bull Float · 6 ft push handle

Add handles to reach across the slab

Overview

A bull float is a wide blade on a long handle, pushed and pulled across a fresh slab right after screeding to level it and close the surface.

We rent 48 in floats with square ends, for working right into a wall, and with rounded ends, which are less likely to dig in. Six-foot push handles add on to reach across a wide slab.

It is the step between screeding and finishing, taking out ripples and high and low spots while the concrete is still wet enough to move.

Raise the handle slightly when pushing away and lower it when pulling back, so the leading edge never digs in. Then let the bleed water evaporate before any edging or troweling.

Best uses

  • Levelling slabs immediately after screeding
  • Removing ripples and high/low spots
  • Closing the surface before edging and troweling

Troubleshooting

Float digs into the slab

Checks to try, in order

  1. Adjust the handle angle so the leading edge is lifted.
  2. The concrete may be too wet — wait a little.

Reference draft — always follow the manufacturer’s manual.

Link to this fixDid this solve the problem?
Handle sections come loose

Checks to try, in order

  1. Check every handle section is fully clicked or twisted together before use.

Reference draft — always follow the manufacturer’s manual.

Link to this fixDid this solve the problem?

Safety

For manual / non-powered

  • Inspect for damage before every use and never exceed the rated load.

Videos & links

Always follow the manufacturer’s manual and site safety rules. Favourites and viewing history are stored on this device.